SRX AWD V6-3.6L (2008)
7. Inspect the fluid color. The fluid should be red or dark brown.
*
If the fluid color is very dark or black and has a burnt odor, inspect the fluid and inside of the bottom pan for excessive metal particles or other
debris. A small amount of "friction" material in the bottom pan is a "normal" condition. If large pieces and/or metal particles are noted in the
fluid or bottom pan, flush the oil cooler and cooler lines and overhaul the transmission. If there are no signs of transmission internal damage
noted, replace the fluid filter assembly, repair the oil cooler, and flush the cooler lines.
*
Fluid that is cloudy or milky or appears to be contaminated with water indicates engine coolant or water contamination. Refer to Engine
Coolant/Water in Transmission (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Symptom
Related Diagnostic Procedures/6L50/6L80/6L90 - Automatic Transmission/Engine Coolant/Water in Transmission) .
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
8. Replace the trans oil level check plug and tighten to 25 N.m (18 lb ft).
9. Inspect for external leaks. Refer to Fluid Leak Diagnosis (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Component Tests and General Diagnostics/6L50/6L80/6L90 - Automatic Transmission/Fluid Leak Diagnosis) .
10. Reset the oil life monitor only if the fluid was changed.
Transmission Fluid Fill Procedure
Transmission Fluid Fill Procedure
Notice: Use Dexron VI transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.
Perform this procedure for vehicles with transmissions that are not equipped with a fill tube and dipstick. Based on accessibility, transmission fluid may
be added through the fluid fill tube plug assembly (1) hole or through the oil level check plug (2) hole in the bottom of the transmission fluid pan.
Tools Required
*
DT 47784 Transmission Fluid Fill Pan Adapter
*
J 45096 Transmission Oil Cooling System Flush and Flow Test Tool
*
J 45096-30 Transmission Cooler Flush Adapters
*
J 45096-40 Transflow Oil Fill Adapter
Fill Tube Plug Method
Fill Tube Plug Method
Notice: Before removing the transmission fluid fill tube plug assembly, thoroughly clean around the plug to prevent dirt or contaminants from
entering the transmission during plug removal. Use compressed air to dislodge any caked dirt that may be stuck on and around the plug area. Use a
mirror to confirm the area is free of dirt before removing the plug. Failure to clean around the plug may result in transmission contamination.
