SRX AWD V6-3.6L (2008)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Data Link Communications Description and Operation (See: Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool References
Control Module References (See: Testing and Inspection/Programming and Relearning)for Scan Tool Information
Circuit/System Verification
1. Ignition OFF, test for less than 5 ohm of resistance between terminal 4 at the data link connector (DLC) and ground.
‹› If greater than the specified value, test the ground circuit for an open/high resistance.
2. Ignition OFF, test for less than 5 ohm of resistance between the DLC terminal 5 and ground.
‹› If greater than the specified value, test the ground circuit for an open/high resistance.
3. Ignition ON, test for B+ between the DLC terminals 16 and ground.
‹› If not the specified value, test the B+ circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, refer to the scan tool user guide.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
and Procedures) after completing the diagnostic procedure.
