cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Impact Sensor > < Procedures|Page 16571
Page 2
background image

Important:  
*

Verify that the inflatable restraint steering wheel module coil is centered.

*

The inflatable restraint steering wheel module coil becomes uncentered under the following conditions:

-

The steering column is separated from the steering gear and allowed to rotate.

-

The spring service lock is pushed down, letting the inflatable restraint steering wheel module coil hub rotate while the inflatable
restraint steering wheel module coil is removed from the steering column.

*

If the inflatable restraint steering wheel module coil becomes uncentered. Refer to Inflatable Restraint Steering Wheel Module Coil
Centering 
 (See: Procedures) .

3. Align and install the inflatable restraint steering wheel module coil with the turn signal switch cancel cam on the steering column.

4. Remove the inflatable restraint steering wheel module coil centering tab (1) if equipped and discard it.

5. Install the inflatable restraint steering wheel module coil retaining ring (1) to the upper steering shaft (2).

Notice:  Gently pull on the lower coil assembly wire in order to remove any wire kinks inside of the column assembly. Verify that there are NO
kinks or bends in the SIR coil assembly wire. If a kink or bend is present, interference may occur with the shaft lock mechanism. Turning the
steering wheel may cut or damage the wire.

6. Connect the inflatable restraint steering wheel module coil electrical harness to the steering column wiring harness and connect the inflatable

restraint steering wheel module coil electrical connectors.

7. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement  (See: Steering and Suspension/Steering/Steering

Column/Service and Repair/Steering Column Trim Covers Replacement) .

8. Install the knee bolster. Refer to Knee Bolster Replacement (Left Hand Drive)  (See: Body and Frame/Interior Moulding / Trim/Dashboard /

Instrument Panel/Service and Repair)Knee Bolster Replacement (Right Hand Drive)  (See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair) .

9. Enable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling  (See: Air Bag(s) Arming and Disarming/Service

and Repair) .

Impact Sensor > < Procedures|Page 16571