SRX AWD V6-3.6L (2008)
Headlamp Alignment Sensor: Service and Repair
Headlamp Leveling Front Suspension Height Sensor Replacement
Headlamp Leveling Front Suspension Height Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service
and Repair) .
3. Disconnect the electrical connector (1).
4. Disconnect the ball and socket (1) from vehicle.
5. Remove the bolt (2) from the sensor.
6. Remove the sensor from the vehicle.
Installation Procedure
1. Position the sensor (1) to the vehicle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the bolt (2) to secure the sensor to the vehicle.
Tighten the bolt to 9 N.m (80 lb in).