SRX AWD V6-3.6L (2008)
Front Steering Knuckle: Service and Repair
Front Suspension
Steering Knuckle Replacement
Tools Required
*
J 24319-B Universal Steering Linkage Puller
*
J 43631 Ball Joint Remover
Removal Procedure
Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove the wheel bearing/hub. Refer to Front Wheel Bearing and Hub Replacement (See: Wheel Bearing/Service and Repair/Front Suspension) .
4. Remove the outer tie rod to steering knuckle retaining nut.
5. Using the J 24319-B , disconnect the tie rod from the steering knuckle.