SRX AWD V6-3.6L (2008)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
Tools Required
J 21854-01 Pivot Pin Remover
Removal Procedure
Caution: Refer to SIR Caution (See: Restraint Systems/Service Precautions/Technician Safety Information/SIR Caution) .
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Steering/Steering Column/Air Bag(s) Arming and Disarming/Service and
Repair) .
2. Remove the steering column from the vehicle. Refer to Steering Column Replacement (See: Steering/Steering Column/Service and
Repair/Steering Column Replacement) .
3. Remove the turn signal switch housing. Refer to Steering Column Tilt Head Replacement (See: Steering/Steering Column/Service and
Repair/Steering Column Tilt Head Replacement) .
4. Remove the tilt spring only. Refer to Steering Column Tilt Spring Replacement (See: Steering/Steering Column/Service and Repair/Steering
Column Tilt Spring Replacement) .
5. Remove 2 pivot pins (1) from the steering column support assembly using J 21854-01 .
6. Remove the boot seal (5).
7. If sensor is not present, remove the following:
1. The steering shaft seal (4)
2. The sensor retainer (3)
8. If sensor is present, remove the following:
1. The sensor locator (2)
2. The sensor assembly (1)
Installation Procedure