SRX AWD V6-3.6L (2008)
6. Remove the wheel bearing/hub retaining bolts (1).
7. Remove the front brake shield (3).
8. Remove the wheel bearing/hub (4) from the knuckle (2).
Installation Procedure
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
1. Position the front brake shield (3) between the knuckle (2) and the wheel bearing/hub (4).
2. Position the wheel bearing/hub (4) in the knuckle (2).
3. Install and hand tighten the wheel bearing/hub retaining bolt (1).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Tighten the wheel bearing/hub bolts (1).
