SRX AWD V6-3.6L (2008)
Wheel Bearing: Service and Repair
Rear Suspension
Rear Wheel Bearing and Hub Replacement
Tools Required
*
J 45859 Wheel Hub Remover
*
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement) .
4. Disconnect the wheel speed sensor electrical connector.
5. Disconnect the wheel speed sensor electrical connector from the backing plate.
6. Remove the wheel drive shaft retaining nut and discard.