SRX AWD V6-3.6L (2008)
1. Install new O-ring seals (3-4) to the pressure control solenoid (1), if the O-rings were previously removed.
2. Install the pressure control solenoid (1) into the control valve body.
3. Install the pressure control solenoid retainer into the control valve body.
4. Connect the electrical wiring harness connector (2) to the pressure control solenoid (1).
5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (See: Service and Repair/Removal and
Replacement) .
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .