SRX AWD V6-3.6L (2008)
1. Install 2 NEW fluid filter seals (1), onto the transmission fluid filter neck. Coat the new seals with a small amount of J 36850 or petroleum jelly
before installation.
2. Install the transmission fluid filter (2) into the case.
Important: Fluid pan gaskets are reusable. Replace the gasket ONLY if the sealing surface is damaged.
3. Install the fluid pan (2) and the gasket (4) at the same time.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the fluid pan bolts (3).
Tighten the bolts to 11 N.m (97 lb in).
5. Fill the transmission to the proper level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General
Diagnostics/5L40-E/5L50-E - Automatic Transmission/Transmission Fluid Check) .
6. Lower the vehicle.
7. Inspect the oil pan gasket for leaks.
