SRX AWD V6-3.6L (2008)
Seals and Gaskets: Service and Repair
5L40-E/5L50-E - Automatic Transmission
Drive Flange and Seal Replacement
Drive Flange and Seal Replacement
Tools Required
*
J 6125-1B Slide Hammer
*
J 23129 Universal Seal Remover
*
J 29873 Injector Nozzle Socket 30 mm
*
J 44765 Seal Installer
*
J 45012 Holding Fixture
*
J 45019 Universal Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the transmission manual shift shaft nut.
3. Disconnect the shift linkage from the transmission.
4. Place the transmission in neutral by rotating the transmission shift shaft clockwise 2 clicks.
5. Remove the exhaust system. Refer to Exhaust System Replacement (See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair) .
6. Disconnect the propeller shaft coupler (1) from the transmission flange. Refer to Rear Propeller Shaft Replacement (RWD) (See: Drive/Propeller
Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Replacement (RWD)) .
7. Push the front propeller shaft toward the rear of the vehicle in order to release the propeller shaft coupler (1) from the transmission drive flange.
