SRX AWD V6-3.6L (2008)
12. Using a suitable pin punch (1), remove the manual shift shaft position switch retaining pin (2).
13. Remove the manual shift shaft detent spring (1) and bolts (2).
14. Position a suitable transmission jack under the transmission support.
15. Remove the transmission support from the body ONLY. Refer to Transmission Support Replacement (See: Body and
Frame/Frame/Cross-Member/Service and Repair/Transmission Support Replacement) .
16. Using the transmission jack, lower the rear of the transmission only enough to allow the manual shift shaft (1) to clear the vehicle floor pan.
17. Extract the manual shift shaft (1) from the transmission case only far enough to allow removal of the manual shift shaft position switch (6).
18. Remove the manual shift shaft position switch (6), the manual shift shaft detent lever (4), the manual shift shaft assembly spacer (3), and the park
pawl actuator (2) as an assembly.
Installation Procedure
1. Install the manual shift shaft position switch (6), the manual shift shaft detent lever (4), the manual shift shaft assembly spacer (3), and the park
