SRX AWD V6-3.6L (2008)
Pinion Flange: Service and Repair
Front Drive Axle
Front Differential Drive Pinion Flange/Yoke, Seal, and Dust Deflector Replacement
Tools Required
*
J 8614-01 Flange and Pulley Holding Tool
*
J 46262 Pinion Sealer
*
J 45012 Holding Fixture
Removal Procedure
1. Raise and support vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement) .
3. Remove the front axle propeller shaft heat shield bolts.
4. Remove the front axle propeller shaft heat shield.
5. Install the J 45012 to the drive pinion flange.
6. While holding the J 45012 remove the drive pinion flange nut.
7. Remove J 45012 from the drive pinion flange.