SRX AWD V6-3.6L (2008)
4. Remove the front axle propeller shaft heat shield.
5. Install the J 45012 to the drive pinion flange.
6. While holding the J 45012 remove the drive pinion flange nut.
7. Remove J 45012 from the drive pinion flange.
8. Install the J 8614-01 to the drive pinion flange.
9. Using J 8614-01 remove the drive pinion flange.
10. Remove the J 8614-01 from the drive pinion flange.
11. Using a flat-bladed tool carefully remove the drive pinion seal. Take care not to damage any sealing surfaces.
Installation Procedure
1. Lubricate the drive pinion flange sealing surface of the drive pinion seal with synthetic gear oil GM P/N 12378514 (Canadian P/N 88901045) or
equivalent.
2. Install the drive pinion seal to the J 46262 .