SRX AWD V6-3.6L (2008)
38. Using the J 42572 , crimp the large seal retaining clamp.
Tighten the large seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 in).
The clamping hold time must be no less than 2 seconds.
39. Inspect the outer joint for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the outer joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
