SRX AWD V6-3.6L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
Important: The seal retaining clamp must not be over-tightened or under-tightened.
15. Using the J 42572 (1), crimp the small seal retaining clamp.
Tighten the small seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 in).
The clamping hold time must be no less than 2 seconds.
16. Insert the remaining grease from the service kit into the seal.
