SRX AWD V6-3.6L (2008)
Important: Keep the cutting edge of the tool against the window.
6. Separate the urethane adhesive from the window.
*
Leave a base of urethane on the pinch-weld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
7. With the aid of an assistant, remove the stationary window from the pinch-weld flange.
Installation Procedure
1. Install a stationary window into the opening. Refer to Adhesive Installation of Bodyside Stationary Windows (See: Service and Repair/Adhesive
Installation of Bodyside Stationary Windows) .
2. Connect the antenna lead located on the rear quarter window.
3. Connect the OnStar(R) connector located on the rear quarter window.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
5. Test the radio and the OnStar(R) system to verify reception.
6. Close the liftgate.
