SRX AWD V6-3.6L (2008)
Caution: Refer to Glass and Sheet Metal Handling Caution .
Important: The upper windshield reveal molding is a one-piece molding and fills the cavities between the body and windshield.
The upper windshield reveal molding cannot be reused if the molding is stretched or damaged.
8. Using a utility knife, carefully cut the upper flap (1) of the windshield reveal molding in order to access the urethane adhesive bead.
9. Prior to cutting the urethane adhesive bead, apply 2 layers of masking tape on the body next to the windshield edge.
Important: Keep the cutting edge of the tool against the window.
10. Separate the urethane adhesive from the window.
*
Leave a base of urethane on the pinch-weld flange.
*
The only suitable lubrication is clean water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
11. Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool. Keep the cutting edge of the utility knife
against the glass. Do this from inside the vehicle.
12. With the aid of an assistant, remove the windshield (1) from the vehicle.
Installation Procedure
