SRX AWD V8-4.6L VIN A (2004)
3. Align the retainers on the garnish molding (1) with the holes in the body pillar.
4. Push the panel inward in order to secure the retainers.
Notice: Refer to Fastener Notice () in Service Precautions.
5. Install the seat belt retractor anchor bolt (3). Ensure that the belt is not twisted.
Tighten the bolt to 45 N.m (33 lb ft)
6. Install the seat belt retractor guide bolt (1). Ensure that the belt is not twisted.
Tighten the bolt to 70 N.m (52 lb ft)
Garnish Molding Replacement - Center Pillar
Garnish Molding Replacement - Center Pillar
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
Caution: Refer to Restraint System Service Precautions () in Service Precautions.
Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door
pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the
SIS.