SRX AWD V8-4.6L VIN A (2004)
Power Seat Control Module: Service and Repair
Memory Seat Module Replacement
SEAT CONTROL MODULE REPLACEMENT - REAR NO.2
REMOVAL PROCEDURE
1. Remove the seat cushion frame.
2. Disconnect the electrical connector (1) from the seat control module.
3. Remove the nuts from the control module (2).
4. Remove the module.
INSTALLATION PROCEDURE
1. Install the seat control module on to seat adjuster.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the seat control module nuts (2).
Tighten
Tighten the nuts to 9 N.m (80 lb in).