SRX AWD V8-4.6L VIN A (2004)
Sunroof / Moonroof Wiring Harness: Service and Repair
SUNROOF WIRING HARNESS REPLACEMENT
REMOVAL PROCEDURE
1. Remove the headliner.
2. Remove the center window panel.
IMPORTANT: Note how the electrical harness is routed and secured to the cable tubes in the motor/actuator compartment.
3. Cut the tie straps that secure the electrical harness in the motor/actuator compartment to the drive and return cable tubes.
4. Disconnect the electric harness connectors from the window and sunshade motor/actuators.
5. Remove the lower C-pillar to electrical harness clip.
6. Disconnect the main sunroof body harness electrical connectors.
7. Pull the sunroof wiring harness (1) down from the motor/actuator compartment (2) into the interior of the vehicle.
8. Remove the electrical harness from the vehicle.
INSTALLATION PROCEDURE
1. One connector at a time (1), pass the electrical harness (4, 3, 2) through the routing hole into the right side of the motor/actuator compartment.
IMPORTANT: Route and secure the electrical harness prior to removal.