SRX AWD V8-4.6L VIN A (2004)
3. Install the master cylinder to the vacuum brake booster.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 brake master cylinder mounting nuts.
Tighten the 2 brake master cylinder mounting nuts to 25 Nm (18 ft. lbs.).
5. Carefully rotate the air inlet panel support bracket onto the master cylinder mounting stud.
6. Carefully install the air inlet panel support bracket push nut to the master cylinder mounting stud.
7. Remove the plugs from the brake pipes.
8. Install the brake pipes to the master cylinder.
Tighten the brake pipe fittings at the master cylinder to 38 Nm (28 ft. lbs.).
9. Connect the electrical connector to the brake fluid level sensor.
10. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure).
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Removal Procedure
1. Remove the master cylinder from the vehicle.
2. Remove the fluid level sensor. Refer to Master Cylinder Fluid Level Sensor Replacement.
3. Drain the brake fluid from the master cylinder reservoir.
4. Carefully tap out the reservoir retaining pins until clear of reservoir.
5. Remove the reservoir from the master cylinder.
6. Remove the seals from the master cylinder reservoir.
Installation Procedure
1. Inspect the reservoir for cracks or deformities. If found, replace the reservoir.
2. Clean the reservoir with clean denatured alcohol, or equivalent.
3. Dry the reservoir with non-lubricated, filtered air.