SRX AWD V8-4.6L VIN A (2004)
![background image](/cadillac/srx_awd/v8-4.6l_vin_a/Page-919001.png)
Knock Sensor: Description and Operation
KNOCK SENSOR (KS) SYSTEM DESCRIPTION
PURPOSE
The knock sensor (KS) system enables the control module to control the ignition timing for the best possible performance while protecting the engine
from potentially damaging levels of detonation. The control module uses the KS system to test for abnormal engine noise that may indicate detonation,
also known as spark knock.
SENSOR DESCRIPTION
This KS system uses one or two flat response two-wire sensors. The sensor uses piezo-electric crystal technology that produces an AC voltage signal
of varying amplitude and frequency based on the engine vibration or noise level. The amplitude and frequency are dependant upon the level of knock
that the KS detects. The control module receives the KS signal through a signal circuit. The KS ground is supplied by the control module through a
low reference circuit.
The control module learns a minimum noise level, or background noise, at idle from the KS and uses calibrated values for the rest of the RPM range.
The control module uses the minimum noise level to calculate a noise channel. A normal KS signal will ride within the noise channel. As engine speed
and load change, the noise channel upper and lower parameters will change to accommodate the normal KS signal, keeping the signal within the
channel. In order to determine which cylinders are knocking, the control module only uses KS signal information when each cylinder is near top dead
center (TDC) of the firing stroke. If knock is present, the signal will range outside of the noise channel.
If the control module has determined that knock is present, it will retard the ignition timing to attempt to eliminate the knock. The control module will
always try to work back to a zero compensation level, or no spark retard. An abnormal KS signal will stay outside of the noise channel or will not be
present. KS diagnostics are calibrated to detect faults with the KS circuitry inside the control module, the KS wiring, or the KS voltage output. Some
diagnostics are also calibrated to detect constant noise from an outside influence such as a loose/damaged component or excessive engine mechanical
noise.