SRX RWD V6-3.6L (2007)
6. Install the seat belt retractor anchor bolt (3). Ensure that the belt is not twisted.
Tighten the bolt to 45 N.m (33 lb ft).
7. Install the seat belt retractor guide bolt (1). Ensure that the belt is not twisted.
Tighten the bolt to 70 N.m (52 lb ft).
Center Pillar Garnish Molding Replacement
Center Pillar Garnish Molding Replacement
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door
pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the
SIS.
1. Disable the SIR system.
2. Remove the front carpet retainers.
3. Remove the rear carpet retainers.
4. Carefully pull outward at the bottom of the lower center pillar trim panel (3) to use the J 38778 in order to release the 3 lower retainer clips.
