SRX RWD V6-3.6L (2007)
6. Install the inner recliner arm covers (1) to the seat back.
7. Install the rear seat back cover.
8. Install the head restraints.
9. Install the rear seat back panel.
10. Install the seat in the vehicle.
11. Calibrate the seat. Refer to Power Folding Seat Calibration.
Rear Seat Number 2 Back Pivot Actuator Motor Replacement - Cushion
Rear Seat Number 2 Back Pivot Actuator Motor Replacement - Cushion
Removal Procedure
1. Remove the seat cushion frame.
2. Disconnect the drive cables from the horizontal motor (1).
3. Disconnect the electrical connector from the motor.
4. Remove the motor.
Installation Procedure