SRX RWD V6-3.6L (2007)
Seat Back: Service and Repair
Front Seat Recliner Replacement
Front Seat Recliner Replacement
Removal Procedure
1. Remove the seat.
2. Remove the seat back frame.
3. Remove the seat cushion.
4. Disconnect the recliner motor electrical connectors.
5. Remove the seat axle retainers (3).
6. Pull the seat track sides apart in order to separate the seat track sides.
7. Remove the nuts (1) securing the recliner to the seat track.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the nuts (1) securing the recliner to the seat track.
Tighten the nut to 65 N.m (18 lb ft).
2. Locate the axles and the seat position drive cable (2) in order to connect the seat track sides.
Important: Insure that the seat position motor cable is fully seated into the drive gear.