SRX RWD V6-3.6L (2007)
1. Install new O-rings to the liquid line.
2. Connect the liquid line to the evaporator.
3. Install a quick connect fitting (1) to the liquid line at the evaporator.
4. Connect the liquid line to the condenser tube.
5. Install a quick connect fitting to the liquid line at the condenser.
6. Install the brake booster.
7. Reposition the surge tank outlet hose to the installed position.
8. Install the surge tank outlet hose bracket nuts to the cowl.
Notice: Refer to Fastener Notice.
Tighten the nuts to 9 N.m (80 lb in).
9. Connect the engine harness electrical connector.
10. Connect the electrical connector to the wiper motor.
11. Install the surge tank.
12. Install the air cleaner assembly.
13. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
14. Leak test the fittings of the component using J 39400-A.
Suction Hose Replacement (LY7 w/o C57)
Suction Hose Replacement (LY7 w/o C57)
Tools Required
*
J 39400-A Halogen Leak Detector
*
J 45689 A/C Quick Joint Tool