SRX RWD V8-4.6L VIN A (2006)
Power Trunk / Liftgate Control Module: Service and Repair
Liftgate Close Actuator Motor Control Module Replacement
Liftgate Close Actuator Motor Control Module Replacement
1. Remove the body side trim panel.
2. Disconnect the power liftgate actuator rod.
Liftgate Close Actuator Motor Control Module Bolt (Qty: 5)
Procedure
-
Disconnect the electrical connector.
-
Cut the tie strap, if equipped.
Tighten
9 Nm (80 lb in)
Liftgate Close Actuator Motor Control Module
If a replacement control module is installed, program the module. See: Testing and Inspection/Programming and Relearning