SRX RWD V8-4.6L VIN A (2006)
6. Align and position the cable assembly (1) cam pin to the cam block (2), located on the lower sunroof frame.
7. Position the track to the lower sunroof frame.
8. Loosely install the rear track assembly screws
9. Measure the tracks side-to-side to ensure that both tracks are parallel.
10. Secure the track to drive tube retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).
11. Install the rear sunshade assembly.
12. Install the rear sunroof vent window.
13. Install the center window panel (2).
14. Perform the sunroof rear vent window/sunshade initialization procedure. Refer to Sunroof Rear Window Initialization Process.
