SRX RWD V8-4.6L VIN A (2006)
4. Install the rear stationary window.
5. Install the rear headliner.
Sunroof Drain Inspection and Cleaning (Rear Vent Window)
Sunroof Drain Inspection and Cleaning (Rear Vent Window)
Inspection and Cleaning Procedure
1. Move the rear window to the vent position.
2. Pour a small amount of water into the sunroof module drain trough. Inspect for a plugged or disconnected drainage system. If the water flow is
restricted, perform the following steps:
Caution: Refer to Safety Glasses and Compressed Air Caution () in Service Precautions.
Important: Use care when using compressed air to clear the sunroof drain hose. Do not exceed 241 kPa (35 psi).
*
Use a flexible wire or 241 kPa (35 psi) of compressed air to clear any material plugging the drain system.
*
Inspect the drainage system for proper water drainage.
*
If water drainage is still not adequate, remove the headliner. Inspect the sunroof drain hoses for proper routing. Refer to Headliner
Replacement in Interior Trim.
3. Install the rear headliner, if necessary.
