SRX RWD V8-4.6L VIN A (2006)
1. Remove the seat track trim cover (1) from the seat.
2. Disconnect the lumbar switch (2) electrical connector.
3. Remove the lumbar switch.
INSTALLATION PROCEDURE
1. Install the lumbar switch (2) into the seat track trim cover (1).
2. Connect the electrical connector.
3. Install the seat track trim cover to the seat.
Seat Switch Replacement - Power
SEAT SWITCH REPLACEMENT - POWER
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 driver's seat and SIR Disabling and Enabling Zone 9 and passenger seat.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Remove the seat cushion from the adjuster track enough to gain access to the power seat switch.