SRX RWD V8-4.6L VIN A (2006)
4. Lightly oil the replacement oil filter gasket with clean oil.
5. Install the oil filter.
Tighten the oil filter to 32 Nm (24 ft. lbs.).
Important: Fill the oil filter with engine oil.
6. Connect the electrical connector to the engine oil pressure switch.
7. Connect the engine oil cooler lines to the adapter, if equipped.
8. Install the left wheel drive shaft, if previously removed.
9. Remove the left side wheelhouse splash shield.
10. Lower the vehicle.
11. Adjust the engine oil level to the full mark.
12. Inspect for oil leaks after engine start up.
