SRX RWD V8-4.6L VIN A (2006)
1. If required, install a new oil pan seal using the following procedure:
1. Clean any residual oil from the seal groove.
2. Work the seal into the pan groove in both directions around the pan.
2. Position the oil pan to the crankcase.
3. Install the oil pan bolts. Tighten the bolts in the sequence shown:
1. First Pass: Tighten the bolts to 15 Nm (11 ft. lbs.).
2. Final Pass: Tighten the bolts to 25 Nm (18 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the engine oil level sensor into the oil pan.
Tighten the sensor to 10 Nm (89 inch lbs.).
5. Connect the electrical connector to the engine oil level sensor.
6. Install the front differential carrier, if equipped.
