cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 17082 > < Diagram Information and Instructions|Page 17080
Page 1
background image

Tail Lamp: Description and Operation

PARK, TAIL, LICENSE AND MARKER LAMPS

The rear tail, stop, and turn signal functions are performed by light emitting diodes (LED) in the tail lamp assemblies. The tail lamp assemblies wrap
around the corner of the vehicle and serve as the rear side marker. The lower portion of each lamp contains reflectors to alert approaching vehicles for
nighttime driving safety. The front park and side marker lamps are part of the front headlamp assembly and use an incandescent bulb. The park, tail,
license and marker lamps are turned on when the headlamp switch is placed in the PARK LAMP or HEADLAMP position or anytime the headlights are
requested. The park lamps are also turned on with the front fog lamps. When the ignition switch is in the ON position, the dash integration module
(DIM) provides battery positive voltage to the controlled positive voltage circuit of the park lamp relay coil. The Fuse Block - Underhood supplies
battery positive voltage to the switch contacts of the park lamp relay. When the headlamp switch is in the PARK LAMP or the HEADLAMP position,
the park lamp switch on signal circuit has ground at G200. In response to this signal, the DIM provides ground to the control circuit of the park lamp
relay coil, which energizes the relay coil. This closes the relay switch contacts. Current flows from the park lamp relay to the LIC/Dimming fuse, LT
PARK fuse and to the RT PARK fuse. From the fuse, the current flows to the park lamps. The front park lamps are grounded at G104 and the tail lamps
are grounded at G401 and G402.. The LIC/Dimming fuse supplies battery positive voltage to the license lamps, underhood lamp and to the DIM park
lamp input, for interior lamps dimming. The license lamps are grounded at G402. The inadvertent power control feature prevents the park lights from
remaining on more than 10 minutes if left on. If the park lights are turned on after the ignition switch has been turned OFF, or is in the ACCY position,
they will remain on until turned off or the battery runs dead.

Diagram Information and Instructions|Page 17082 > < Diagram Information and Instructions|Page 17080