SRX RWD V8-4.6L VIN A (2006)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Remove the oil filter adapter.
2. Remove the oil pressure sensor and/or switch from the oil filter adapter.
3. Clean and inspect the oil filter adapter. Refer to Oil Filter Adapter Cleaning and Inspection.
Installation Procedure
1. Install a new O-ring on the oil pressure switch.
2. Install the oil pressure switch to the oil filter adapter.
Tighten the oil pressure sensor and/or switch to 16 Nm (12 ft. lbs.).
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
