SRX RWD V8-4.6L VIN A (2006)
Fuel Injector: Service and Repair
Fuel Injector Sight Shield Replacement
Fuel Injector Sight Shield Replacement
Removal Procedure
1. Remove the cross vehicle brace, if necessary.
2. Clean the fuel injector sight shield at the power steering and engine oil fill cap locations.
3. Remove the power steering and engine oil fill caps.
4. Lift the sight shield up from the front and pull forward to disengage the rear tab from the bracket.
Installation Procedure
1. Align the rear tab with the slot in the rear bracket and push the sight shield inward to engage.
2. Push the sight shield down and align the ball studs on the engine with the holes in the sight shield.
3. Install the power steering and engine oil fill caps.
4. Install the cross vehicle brace, if necessary.