SRX RWD V8-4.6L VIN A (2006)
Knock Sensor: Service and Repair
Knock Sensor (KS) 1 Replacement
KNOCK SENSOR (KS) 1 REPLACEMENT
REMOVAL PROCEDURE
1. Remove the intake manifold.
2. Disconnect the electrical connector (3) from the knock sensor (KS) (4).
3. Remove the bolt in the center of the KS.
4. Remove the KS (4) from the engine block.
INSTALLATION PROCEDURE
1. Thoroughly clean the mating surfaces of the KS and the engine block. The entire contact surface of the KS must lie directly on the engine block.