SRX RWD V8-4.6L VIN A (2006)
1. When replacing the VCIM, record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label
on the new VCIM.
2. Reconnect the electrical connectors the module.
3. Install the module onto the vehicle.
Tighten the nuts to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the right rear body side trim.
5. Reconfigure the OnStar(R) system. Refer to OnStar Reconfiguration.
IMPORTANT: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to reconfigure the
system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this
version of the OnStar(R) system. This action will cause a DTC to set.
