SRX RWD V8-4.6L VIN A (2006)
62. Bend flat the twisted connection.
63. Secure and insulate the 3 wire connection to deployment harness using electrical tape.
64. Connect the deployment harness to the I/P module in-line connector.
65. Route the deployment harness out of the passenger side of the vehicle.
66. Disconnect the passenger side air bag/pretensioner yellow connector (1) from the vehicle wiring harness located under the front of driver seat.
67. Cut the four SIR wires (2 for side air bag and 2 for pretensioner) leading to the yellow harness connector from the vehicle, leaving at least 16 cm
(6 in) of wire at the connector.
68. Strip 13 mm (0.5 in) of insulation from all four SIR wires connector leads (2 for side air bag and 2 for pretensioner).
