SRX RWD V8-4.6L VIN A (2006)
8. Lower the headliner to gain clearance to the roof rail module.
9. Remove the fasteners from the roof rail module.
10. Remove the tether from the windshield pillar (1).
11. Remove the roof rail module from the roof.
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is
securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR
system repairs.
2. Insert the roof rail module tether to the windshield pillar (1).
3. Install the mounting fasteners to the inflatable restraint roof rail module.
Tighten the fasteners to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
