SRX RWD V8-4.6L VIN A (2006)
Knee Diverter: Service and Repair
Knee Bolster Replacement
KNEE BOLSTER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left hand closeout panel.
2. Remove the screws (2) securing the knee bolster trim (1) to the knee bolster bracket.
3. Remove the knee bolster trim (1).
INSTALLATION PROCEDURE
1. Install the knee bolster trim (1).
2. Install the retaining screws (2).
NOTE: Refer to Fastener Notice.
Tighten the fasteners to 2 N.m (18 lb in).
3. Install the lever retainers screws.
Tighten the fasteners to 2 N.m (18 lb in).
4. Install the left hand closeout panel.
