SRX RWD V8-4.6L VIN A (2006)
Negative: Service and Repair
Battery Negative Cable Disconnect/Connect Procedure
BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE
REMOVAL PROCEDURE
1. Turn OFF all the lamps and accessories.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Turn the ignition OFF.
3. Disconnect the battery negative cable (2) from the battery.
INSTALLATION PROCEDURE
1. Connect the battery negative (2) cable to the battery.
Tighten the bolt to 17 N.m (13 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Clean any existing corrosion from the battery terminal, the battery cable bolt, and the battery cable.
2. Power sunroof calibration:
1. Turn the ignition switch to the RUN position.
2. Turn the power sunroof switch to the closed position. After the sunroof fully closes and the motor stops, press and hold in the switch for 3
seconds.
3. Turn the power sunroof switch to the tilt position. After the sunroof reaches the tilt position and the motor stops, press and hold in the switch
for 3 seconds.
4. Turn the power sunroof switch to the full open position. After the sunroof is fully open and the motor stops, press and hold in the switch for 3
seconds.
5. Turn the power sunroof switch to the closed position. After the sunroof fully closes and the motor stops, press and hold in the switch for 3
seconds.
3. Power windows calibration:
1. Repeat these steps for each window.
2. Turn the ignition switch to the RUN position.
3. Press the power window switch to the down position. After the window is in the full down position, press and hold the switch in the down
position for 3 seconds.