SRX RWD V8-4.6L VIN A (2006)
Control Arm: Service and Repair
Rear Suspension
Upper Control Arm Replacement
Upper Control Arm Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel.
3. Remove the upper control arm to knuckle retaining nut.
4. Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
Using the J 43631, disconnect the upper control arm from the knuckle.
