SRX RWD V8-4.6L VIN A (2006)
Tires inflated to a higher than recommended pressure can contribute to the following conditions:
^
A hard ride
^
Tire bruising
^
Rapid tread wear at the center of the tire
Tires inflated to a lower than recommended pressure can contribute to the following conditions:
^
Tire squeal on turns
^
Hard steering
^
Rapid and/or uneven wear on the outer edges of the tread
^
Tire rim bruises and tire rim rupture
^
Tire cord breakage
^
High tire temperatures
^
Sluggish vehicle handling
^
Higher fuel consumption
Unequal pressure on the same axle can cause the following conditions:
^
Uneven braking action
^
Steering lead
^
Imprecise vehicle handling
Tire Chain Usage Description
When you use tire chains, most current vehicles require the following chain types:
^
SAE Class S or 1100 Series, Type PL tire chains (1)
^
SAE Class U or 1200 Series, Type P tire chains (2)
^
1800 Series Lug Reinforced tire chains (3)
These chains are specially designed in order to limit the fly-off effect that occurs when the wheel rotates.
Manufacturers of tire chains have a specific chain size for each tire size. These ensure a proper fit when the chains are installed. Purchase the correct
chains for the tires on which the chains will be used. Do not use rubber adjusters to take up slack in chains that are loose due to incorrect size. Always
follow the chain manufacturers installation instructions.
The use of chains may adversely affect handling. When using chains, remember the following information:
^
Ensure that the vehicle is designed for chain clearance.
^
Adjust the speed to road conditions.
^
Avoid sharp turns.
^
Avoid locked-wheel braking in order to prevent chain damage to the vehicle.
^
Install the chains as tightly as possible on the drive tires. Tighten the chains again after driving 0.4-0.8 km (0.25-0.5 mi). Do not use chains on the
non-drive tires. These chains may contact and damage the vehicle. If you use chains on the non-drive tires, ensure that there is enough clearance.
^
Do not exceed 70 km/h (45 mph). Do not exceed the chain manufacturers speed limit, if lower.
^
Drive in a restrained manner. Avoid large bumps, potholes, severe turns, and other maneuvers that cause the tires to bounce up and down.