cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

SIR Disabling and Enabling Zones|Page 14528 > < SIR Disabling and Enabling Zones|Page 14526
Page 16
background image

16. Connect the right roof rail module yellow connector (2) to the roof rail module (1).
17. Install the CPA (3) to the right roof rail module connector (2).
18. Release the rear seat back.
19. Install the right carpet retainer trim.

20. Install both the AIR BAG (IGN) fuse in the right rear fuse center (1) and the AIR BAG (BATT) fuse from the left rear fuse center (2).
21. Install the right and left rear fuse center covers.
22. Install the rear seat.
23. Use caution while reaching in and switch the ignition to the ON position.The AIR BAG indicator will flash, then turn OFF.
24. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System

Check - Vehicle in Vehicle DTC Information.

SIR Disabling and Enabling Zone 9

SIR DISABLING AND ENABLING ZONE 9

DISABLING PROCEDURE

1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Place the ignition to the OFF position.

SIR Disabling and Enabling Zones|Page 14528 > < SIR Disabling and Enabling Zones|Page 14526