STS V8-4.6L VIN A (2005)
2. Install the KS (1) and bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: DO NOT use washers, spring washers, or toothed washers when installing the knock sensor. Tighten the bolt to the proper torque.
Tighten bolt to 20 N.m (15 lb ft).
3. Ensure that the wiring harness is installed correctly.
IMPORTANT: The KS wiring harness is held in place with several retaining clips.
4. Connect the KS electrical connector (2).
5. Install the intake manifold.