STS AWD V8-4.6L VIN A (2006)
4. Install the 4 EBCM to BPMV screws.
Tighten
Tighten the 4 EBCM to BPMV screws in sequence (1-4) to 5 Nm (44 lb in).
Note: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON
position.
5. Connect the EBCM electrical connector (1) to the EBCM (3).
6. Rotate the EBCM connector tab (2) rearward to the locked position.
7. Install the washer solvent container bracket, if equipped. Refer to Solvent Container, Pump, Level Sensor Replacement-Windshield Washer in
Wipers/Washer Systems.
8. Install the wheelhouse liner. Refer to Fender, Fender Insulator, Wheelhouse Liner Replacement-Front in Body Front End.
9. Install the air deflector shield.
10. Lower the vehicle.
11. Connect the negative battery cable.
12. If installing a new EBCM it is necessary to program the EBCM.
13. Perform the Diagnostic System Check - Vehicle.
Disclaimer