STS AWD V8-4.6L VIN A (2006)
2. Install the selected shims (9) on the pinion housing (3).
3. Install a NEW O-ring (11) in the groove on the pinion housing.
4. Important: Inspect the bearing housing for nicks and burrs. Remove if necessary.
Apply a light coat of gear lube to the bearing housing to ease installation.
5. Important: Inspect the carrier pinion housing bore for nicks or burrs. Remove if necessary.
Apply a light coat of gear lube into the pinion housing bore of the carrier.
6. Using J 25070, heat the carrier.