STS RWD V8-4.6L (2007)
Sunroof / Moonroof Track: Service and Repair
Sunroof Track Timing/Synchronization
1. Before retiming the module, the actuator /motor must be removed. Refer to Sunroof Motor/Actuator Replacement (Smart Motor). See: Sunroof /
Moonroof Motor/Service and Repair/Removal and Replacement
Important: If the sunroof actuator is the only part being serviced, follow the power sunroof actuator replacement procedure for the
sunroof actuator to sunroof window timing. Refer to Sunroof Motor/Actuator Replacement (Smart Motor). See: Sunroof / Moonroof
Motor/Service and Repair/Removal and Replacement
A new replacement power sunroof actuator is set to the fully closed and flush position at the factory.
2. Remove the sunroof window.
3. Fabricate a gage (2) 46.8 ± 0.5 mm (1.84 in) wide (A).
A piece of thick paper will work.
4. Set the gage into the track near the rear of the opening between the move drive slide (1) and the bracket.
5. Move the drive slide fore or aft in order to get the proper setting.
6. Repeat steps 3 and 4 for the other side.
7. Install the sunroof window.
8. Install the sunroof actuator.
9. Operate the sunroof through all functions to ensure proper operation.
