XLR V8-4.6L VIN A (2006)
9. Remove the rear window panel trim. Lift upwards to slide the trim out from behind the end of the console. Route the seat belts from both ends.
Installation Procedure
1. Install the rear window panel trim behind the end of the console. Route both seat belts through the trim panel.
2. Install the escutcheon to the panel trim.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the retaining screws to the panel trim.
Tighten the screws to 2.5 N.m (22 lb in).
4. Install the rear console retaining nuts.
Tighten the nuts to 10 N.m (89 lb in).
5. Install the lock pillar trim.
6. Install the stowage trim to the rear compartment panel.
7. Install the roof bar tube assemblies.
8. Position the driver and passenger seat in the customer set position.
9. Power operate the folding top system to the fully up and latched position.
Trim Panel Replacement - Rear Quarter
Trim Panel Replacement - Rear Quarter
Removal Procedure
1. Open the rear compartment.
2. Lower the rear compartment partition.